S60 L5-2.4L VIN 64 B5244S6 (2003)
Remove:
-
the nuts and screws for the steering gear
-
the screw for front engine pad and sub-frame
-
the screws securing the torque rod mounting on the gearbox
Unhook the power steering fluid line from the sub-frame
Removing the screws from the sub-frame support brackets (both sides)
Position mobile jack 998 5972 JACK See: Tools and Equipment/998 5972 Jack with fixture 999 5972 FIXTURE See: Tools and Equipment/999 5972
Fixture to light contact under the sub-frame's right side.
Remove the sub-frame screws on the right-hand side. Unscrew the screws so that at least five threads remain. Remove the jack.
Ensure the stub axle is twisted for turning left. Unhook the control arm from the ball joint. Remove the drive shaft from the hub.
Install protective sleeve 999 5562 PROTECTIVE SOCKET See: Tools and Equipment/999 5562 Protective Socket , which is locked in place with the
nut for the ball joint.
Move the spring strut slightly backwards. Take care that the control arm does not damage the drive shaft boot.
Lowering the sub-frame
Position the mobile jack lightly applied under the left side of the sub-frame. Remove the front and rear screws from the sub-frame.
Carefully lower the frame a little. Check that the screws for the steering gear release from the frame and the control arm releases from the ball joint.
Lower the sub-frame completely and let it hang free.
