S60 L5-2.4L VIN 64 B5244S6 (2003)
Applies only to right-hand drive cars
Install the cross member.
Ensure that the brake pipe is pressed into place in its holder.
Tighten the member. Tighten to 25 Nm
Installing the screw for the drive shaft
Use a new screw. Tighten to 50 Nm
Clean the ABS sensor seat. Install the sensor on the stub axle. Tighten to 10 Nm
Installing components on the sub-frame
Install:
-
the screw for the cable conduit
-
the holder for the ground lead
Applies only to cars with parking heaters
Install the heater on the sub-frame.
Install the fuel line for the heater in the holders on the sub-frame.
Installing the splash guard under the engine