S60 L5-2.4L VIN 64 B5244S6 (2003)
Seals and Gaskets: Service and Repair
Seal, Drive Shaft, Replacing
Seal, drive shaft, replacing
Special tools:
999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801 Standard Shaft
999 5541 PUNCH See: Tools and Equipment/999 5541 Punch
Left-hand side
Preparatory removal
See Drive shaft left, replacing, B5254T2, M58, B5254T2, M56 See: Axle Shaft Assembly/Service and Repair/Drive Shaft Left, Replacing.
Remove the drive shaft seal
Use a jimmy bar with a flat surface. Turn the flat surface towards the transmission housing.
Install the drive shaft seal
Note! Clean thoroughly before installing the new seal
Apply a small amount of grease to the sealing lip.
Use drift 999 5541 PUNCH See: Tools and Equipment/999 5541 Punch and shaft 999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801
Standard Shaft.
Place the side of the drift marked M56 against the drive shaft seal.
Install the drive shaft in the transmission
Right-hand side
Preparations
See and Drive shaft right, replacing See: Axle Shaft Assembly/Service and Repair/Drive Shaft Right, Replacing