S60 L5-2.4L VIN 64 B5244S6 (2003)
Remove the drive shaft seal
Use a jimmy bar with a flat surface. Turn the flat surface towards the transmission housing.
Install the drive shaft seal
Note! Clean thoroughly before installing the new seal
Apply a small amount of grease to the sealing lip.
Use drift 999 5541 PUNCH See: Tools and Equipment/999 5541 Punch and shaft 999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801
Standard Shaft.
Place the side of the drift marked M56 against the drive shaft seal.
Install the right drive shaft in the transmission
See Drive shaft right, replacing See: Axle Shaft Assembly/Service and Repair/Drive Shaft Right, Replacing
See, , and