S60 L5-2.4L VIN 64 B5244S6 (2003)
Seals and Gaskets: Service and Repair
Seal, primary shaft, replacing
Special tools: 999 7003, 999 7004
Removal
Note: As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.
Note: Preparations, see Transmission, removing
Removing the clutch cylinder
Remove the rubber seal from the clutch cover.
Move it inwards on the pipe towards the clutch cylinder.
Pull out the retaining clip locking the quick release connector on the pipe to the junction.
Remove the adapter. Keep it in a plastic bag to prevent contamination. Install a protective plug in the end of the pipe.
Remove the clutch cylinder.
Clean the mating surfaces in the clutch cover.
Check any leakage from the transmission.
Installing the extractor for the primary shaft seal
Tap in the extractor for the primary shaft seal. Use extractor 9997003.
Note: The screw and socket must be unscrewed when tapping on the extractor. Tap the tool into the seal. Tighten the inner socket. Counter hold the
outer part at the same time so that the tool expands against the seal.
Tighten the screw in the extractor. Remove the seal.