S60 L5-2.4L VIN 64 B5244S6 (2003)
Installation
Installing the new primary shaft seal
Lubricate the lip of the primary shaft seal. Use grease, P/N 1161241-3.
Use drift 9997004 when installing the primary shaft seal.
Pull the sliding drift sleeve forward. Press the seal into place.
Guide drift on primary shaft. Tap in the seal until the sliding drift sleeve is against the transmission and in the rear sleeve position.
Installing the clutch cylinder
Tighten the screws. Tighten to 10 Nm. Thread the rubber seal onto the pipe with the boot turned towards the clutch cylinder.
Remove the protective plug. Install the junction.
Always use a new quick-release connector with a rubber seal.
Lubricate the rubber seal using a drop of brake fluid. This facilitates joining.
Press the pipe into the junction. Lock the pipe using the clip.
Installing the rubber seal for the pipe in the clutch cover