S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
detaches completely
-
Place the bumper on a suitable underlay that will not damage the paint.
Remove:
-
the rivet (1) on the bracket (2) for the silencer. Use cutting nippers
-
the screws (3) on the bracket
-
the bracket by detaching the rubber mountings (4). The bracket will not be used again.
-
Remove the screws (1) and the bracket (2) from the right side of the rear of the car The bracket will not be used again.
-
Install masking tape on the outside of the bumper to avoid damage from the saw.
Install masking tape opposite the cutting points and over the bumper cover
-
Leave the masking tape in place throughout the installation procedure
-
Cut along the markings for the hole for the connection stud (see the inside of the bumper). Carry out the operation so that the markings remain in
the bumper afterwards
-
After cutting, smooth off the edges using a file.
Installing the detachable tow hitch (including the cable harness)