S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Fold up the holder on the rear end as illustrated
-
Position the rear end in the lower edge of the centre console so that the rear end locating pins align with the corresponding holes in the centre
console
-
Reconnect the connectors. Press the connectors into the groove. If there is a cable beside the holder, secure it
-
Fold up the rear end towards the top edge of the centre console. Press the locating pin and catches at the top edge and on the sides until they
engage
-
Tighten the upper mounting for the rear end piece using the two screws
-
Reinstall the centre console locker cover. Secure the centre console locker using the two screws
-
Hook the panel into place beside the bracket for the cover.
-
Fold the holder down towards the rear end. Press the holder into place.
Use
With waste paper bags:
-
Fold up the holder until it locks in the uppermost position
-
Remove the inner section of the holder by pulling downwards. At the same time hold the holder in place.
