S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
possible.
Applying liquid gasket
Wipe the surfaces dry. Apply liquid gasket 11 61 059 to the intermediate section.
The surface must be completely covered without any excess. Use roller 951 2767 Roller See: Tools and Equipment/951 2767 Roller. Thoroughly
lubricate all the bearing shells and the thrust bearing's surface.
Tightening the intermediate section
Install the two old screws for the flywheel and carrier plate at the rear edge of the crankshaft. Lift these and the front of the crankshaft.
Carefully position the crankshaft in the block. The crankshaft must not be turned before the intermediate section has been torque tightened. Position the
intermediate section. Lubricate and install all the screws.
Note! Use new M10 bolts.
Caution! The M8-bolts on the exhaust side have two lengths.
Install the intermediate section and the screws on the exhaust side at bearing recesses 2 and 5.
Pull down the intermediate section. Tighten the screws. See Tightening torque See: Specifications/Tightening Torque.
Marking the connecting rod (where applicable)