S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Lever the sealing ring off the crown wheel shaft.
Use a screwdriver or a jimmy bar.
Installing a new sealing ring
Install the new sealing ring for the drive shaft.
Lubricate the seal using wheel bearing grease, P/N 1161241-3.
Use drift 999 5654 Punch See: Tools and Equipment/999 5654 Punch. Tap in the ring to stop.
If also replacing the seal for the crown wheel shaft, proceed to replacing.
Note! To install the drive shaft, see Bevel gear, B5254T2, M58 See: Service and Repair/Removal and Replacement/Automatic Transmission
Components/Bevel Gear, Replacing Bevel gear, B5254T2, AW50/51 AWD See: Service and Repair/Removal and Replacement/Automatic
Transmission Components/Bevel Gear, Replacing Bevel gear See: Service and Repair/Removal and Replacement/Automatic Transmission
Components/Bevel Gear, Replacing.
Sealing ring for crown wheel shaft for bevel gear, replacing
Marking the position of the adjustment nut
Mark the position of the adjustment nut in relation to the housing with a scriber.
Measure the height between the nut and housing. Make a note of the measurement.