S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
Tap in the extractor for the primary shaft seal. Use extractor 9997003
Note: The screw and socket must be unscrewed when tapping on the extractor.
Tap the tool into the seal. Tighten the inner socket. Counter hold the outer part at the same time so that the tool expands against the seal. Tighten the
screw in the extractor. Remove the seal.
Installation
Installing the new primary shaft seal
Lubricate the lip of the primary shaft seal. Use grease, P/N 1161241-3. Use drift 9997004 when installing the primary shaft seal. Pull the sliding drift
sleeve forward. Press the seal into place. Guide drift on primary shaft. Tap in the seal until the sliding drift sleeve is against the transmission and in the
rear sleeve position.
Installing the clutch cylinder