S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
Tighten the screws. Tighten to 10 Nm.
Thread the rubber seal onto the pipe with the boot turned towards the clutch cylinder. Remove the protective plug. Install the junction. Always use a
new quick-release connector with a rubber seal.
Lubricate the rubber seal using a drop of brake fluid. This facilitates joining. Press the pipe into the junction. Lock the pipe using the clip.
Installing the rubber seal for the pipe in the clutch cover
Ensure that the rubber seal locates all the way around.
Note: Follow-up work: To install the transmission, see Installing the transmission.