S60 T5 L5-2.4L Turbo VIN 54 B5244T5 (2006)
Knock Sensor: Service and Repair
Knock sensor (KS), replacing
Removal and Installation
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Removing the knock sensor (KS)
Disconnect the battery negative lead. First read Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Remove the intake manifold and gasket. See Intake pipe/gasket, replacement .
Remove:
-
the screws for the knock sensors (KS)
-
the tie strap at the connector. Pull the sensors downwards and past the starter motor bracket at the rear edge.
Installing knock sensors (KS)