S70 L5-2.4L VIN 61 B5244S (2000)
-
The electronic Throttle Body (TB). Use a new gasket. Tighten to 1O Nm (7.4 ft. lbs.).
Installing the intake manifold/gasket
Note! Ensure that the gasket faces are clean.
Install
-
a new gasket held in position by the lower screws for the intake manifold.
-
the intake manifold. Do not forget the crankcase ventilation hose which comes up through the gap between the second and third ducts.
-
position the delivery line between the first and second duct.
-
the three upper screws. Tighten all screws starting from the center. to 20 Nm (15 ft. lbs.).
Finishing
Install
-
the fuel rail. Press together the quick-release connector. Use new screws. Tighten to 1O Nm (7.4 ft. lbs.).
-
the connectors for the injectors and the cover plate.
-
the vacuum hoses according to earlier marking.
-
the plastic charge air pipe and the hose to the Charge Air Cooler (CAC).
-
the connectors for the sensors in the plastic charge air pipe.