S70 L5-2.4L VIN 61 B5244S (2000)
NOTE: Use a wooden block as shim.
-
Lift the engine to access the control arm screws.
-
Remove:
-
The four screws ( 1 ) for the control arm.
-
The control arm.
Installing the control arm on the left-hand side
NOTE: Ensure that there is no exhaust leakage.
-
Install the control arm on the sub-frame. Use new screws. Tighten to 65 Nm. Angle-tighten 90°. Use bevel protractor 951 2050. Lower and
remove the mobile jack.
Installing the control arm on the right-hand side
-
Install the control arm on the sub-frame. Use new screws. Tighten to 65 Nm. Angle-tighten 90°. Use bevel protractor 951 2050. Lower and
remove the mobile jack.
Installing the engine mountings
-
Install screws ( 1 ) for the engine pad on the right side. Tighten to 35 Nm. Angle-tighten 90°. Use bevel protractor 951 2050.
NOTE: Use new screws.