S70 AWD L5-2.4L Turbo VIN 56 B5254T (1999)
![background image](/volvo/s70_awd/l5-2.4l_turbo_vin_56_b5254t/Page-1279002.png)
Note: Clean around sensor carefully before removing it.
^
Remove sensor mounting bolt and extract sensor.
^
Remove wheel sensor leads.
^
Remove sensor.
Installing wheel sensors
^
Clean sensor seat free of dirt and rust so sensor ends up in right position relative to pulse wheel.
^
Brush any dirt off of pulse wheel. Use a soft brush.
^
Install sensor leads and sensor and tighten bolt to 10 Nm (8 ft. lbs.).
Installing wheel sensor connector
^
Run a lead down through hole for level sensor and fuel pump to rear axle.
^
Attach new connector to lead.
Note: Protect connector from dirt and moisture.
^
Pull connector up alongside fuel hoses to the other connector.
^
Connect connector to wheel sensors. Install leads to opening.
Finishing