S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Pull the end mounting apart.
Remove the deformation element (F), the plastic washers and the O-ring.
Replace the deformation element.
Note! The O-ring (A) in the repair kit must be used for all models.
Installing the WHIPS system
The green indicator (G) supplied must only be installed on the deformation element in cars up to the following chassis number.
S80: -167986
V70 Volvo Torslanda (VTM): -56776
V70 Volvo Europe Car (VEC): -57997
V70XC: -6475
S60: -1499
Install:
-
the deformation element (F), the plastic washers and the O-ring
-
the spindle (E)
-
the nut (B). Tighten the nut. Tighten to 17 Nm +/-1 Nm
-
the spring (D).
Position the seat in the normal position.
Note! The two plastic washers and the O-ring must be correctly positioned. Check that the indicator pin is intact and is correctly positioned
after installation.
Reinstall all other removed components.
