S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the locking sleeves over the cable splices on the junction connector. Pull off the connectors from the junction connector
-
Place the junction connector to one side. It will not be reused.
-
Lubricate the O-rings on the connectors for the relay and front engine block heater socket. Use low temperature grease, (P/N 1161417-9).
Note! Do not get any grease on the contact surfaces of the connector.
-
Take the relay from the kit. Connect the cable for the front engine block heater socket (1), the cable for the engine block heater (2) and the cable
for the passenger compartment connector socket (3). Firmly press the cable splices together.
