S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Press the locking sleeves from the kit over the joints.
Note! The large locking sleeve must be pressed over the connector on the cable from the front engine block heater socket.
-
Tighten the relay on the underneath of the side member. Use a screw from the kit in the same hole as the one in which the junction connector is
positioned
-
Connect the ground lead for the relay to the existing ground terminal at the front end of the side member. Tighten properly
-
Secure the ground lead excess by the cable for the front engine block heater socket. Use the tie strap (1) from the kit.
-
Tighten the single cable for the relay on top of the right front corner of the sub-frame. Tighten the cable together with the other wiring for the
engine block heater/passenger compartment connector socket
-
Secure the single cable for the relay at the existing wiring. Use the tie strap (1) from the kit.
