S80 L6-3.2L VIN 98 B6324S (2007)
-
Take cable harness (A) and foam tape pieces from the kit.
-
Remove the protective tape and wrap the foam tape around the relay.
-
Take the cable harness (A) and connect the grey connector to the connector from the cooler/hotbox that was previously routed.
-
Route the cable harness along the existing cable harness to the rear edge of the wheel housing and secure it with two cable ties from the kit.
Steps 15-17 apply to cars without a 12V socket.
-
Secure the cable with the white 2-pin male connector (1) together with the relay (1), at the existing cable harness with cable ties from the kit.
-
Connect the existing white 2-pin male connector (2) to the white 2-pin female connector (3) in the pre-routed cable harness.
-
Route the remaining long cable with two green connectors along the rear member to the left-hand tail lamp.
