S80 L6-3.2L VIN 98 B6324S (2007)
-
Connect the existing green 5-pin male connector (1) to the green 5-pin female connector (2) in the pre-routed cable harness.
-
Secure the excess cable (3) with a cable tie from the kit.
Applies to cars with trailer module (TRM) and/or parking assistance camera (PAC).
-
If the car is equipped with a trailer module (TRM), PAC or both: Disconnect the green male connector from the TRM/PAC and connect it to the
cable harness green 5-pin female connector. Connect the remaining male connector to TRM/PAC.
-
Clamp the pre-routed cable harness at the existing cable harness with four cable ties from the kit.
Steps 18-20 apply to cars with a 12V socket.
-
Clamp the cable with the relay (1) at the existing cable harness with cable ties from the kit.
-
Connect the existing white 2-pin male connector (2) that was disconnected from the 12V socket to the white 2-pin female connector (3) in the
pre-routed cable harness.
The cable with the white 2-pin male connector (4) is later connected to the 12V socket when the side panel is reinstalled.
-
Route the remaining long cable with two green connectors along the rear member to the left-hand tail lamp.
