S80 L6-3.2L VIN 98 B6324S (2007)
-
Undo the clamps from the dust excluder on the steering servo and move it aside to expose the joint between the rack and the inner track rod end.
-
Undo the inner track rod end from the power steering's rack. Use the information in VIDA under group "wheel suspension, steering, removing
inner track rod end".
-
Discard the clamps and dust excluders. There are new ones in the kit.
For cars with ZF power steering
-
When installing a steering deflection limiter on cars with this type of power steering, there is always a washer fitted. This is to be removed and
replaced with the washer from the kit. Use the kit with part no. 30793189
-
Remove the existing washer from the rack and fit a new T= 17.5 mm (11/16 ") from the kit. The washer can only be fitted one way.
For cars with ZF power steering
-
Reinstall the inner track rod end on the power steering's rack. Use the information in VIDA under group "wheel suspension, steering, removing
inner track rod end".
-
Use new clamps and dust excluders from the kit.
-
Repeat steps 9-11 for the other side.
For cars with 8-cylinder engine
-
Reinstall the radiation guard and tighten the screws to 10 Nm (7.5 lb.ft.).
