S80 L6-3.2L VIN 98 B6324S (2007)
Install the filler plug (Torx 55). Use a new O-ring. Moisten the new O-ring using transmission fluid and tighten.
Installing the air cleaner (ACL)
Install the air cleaner (ACL) housing. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service
and Repair
Checking the oil level
Connect the diagnostic equipment and read the transmission fluid temperature continuously.
Start the engine.
Note! Leave the engine running during the entire check.
Note! The following measure must be carried out quickly to avoid overheating the fluid.
Run through all the positions between P and D on the gear selector. Stop at each position for at least 2 seconds. Perform this process twice.
Allow the transmission fluid to heat up to 50 °C.
Note! The fluid will not heat up faster by stalling.
Place a lower drip shield on the floor under the vehicle.
While the engine is running, remove the integrated level plug (Torx 40).