S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
-
Release the catch on the rear. Use a screwdriver
-
Lift and pull out the control module.
Check
Check that the control module connectors are intact.
Installing the control module
-
Press the control module into place so that the catch on the rear engages
-
Position the connector. Carefully press the connector down.
Note! The pins are fragile. Check that the connector goes straight down into the control module.
-
Tighten the screw for the connector
-
Check that the connector cover is correctly positioned. Remedy if necessary
-
Install the relays and shunts. For relay locations, see instruction Relay location.
-
Install the integrated relay / fusebox, see Installing the integrated relay / fusebox in the cargo compartment.
Ordering software
Order the software. See: Testing and Inspection/Programming and Relearning/Software Downloading.
Other information
For the location of other relay and fuse boxes, see Relays, fuse boxes and wiring See: Power and Ground Distribution/Locations.