V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Receiver Dryer: Service and Repair
Receiver Drier
Receiver drier
Warning! Follow the applicable safety rules for work with air conditioning units, see Safety instructions when handling refrigerant See: Service
Precautions/Technician Safety Information/Safety Instructions When Handling Refrigerant
Read the instructions about slow and fast leakage,
General
Note! Always change O-rings when replacing accumulator/dryer.
Drain the refrigerant from the system, see Draining See: Service and Repair/Draining
Dryer, removing
Remove the clamp that holds the battery.
Remove the cable between dryer and condenser as well as between dryer and evaporator.
Seal the openings.
Disconnect the pressure monitor's connector.
Remove the two attaching nuts from the support.
Remove the dryer and support.
Transfer the support to the new dryer
Mark the support's position on the old dryer.
Loosen the clamp's bolt and remove the support. Transfer the marking from the old dryer to the new one and install the support.
Push in the rubber between dryer and the support's clamp.
Tighten the support's clamp finger-tight.
Transfer the pressure monitor to the new accumulator/dryer.
Lube the O-rings with compressor oil.
Pressure monitor, tightening torque: 18 Nm.