V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Accumulator/dryer, installing
When replacing, accumulator/dryer must be filled with 20 cm3 oil.
Lube the new O-rings with compressor oil.
Install the dryer with the support and tighten the two nuts finger-tight.
Install the cables in position.
Tightening torque, cable from evaporator to dryer: 10 Nm.
Tightening torque, cable from condenser to dryer: 10 Nm.
Tighten down the dryer support, tightening torque: 10 Nm.
Place the dryer in correct position and tighten the support's clamp with 10 Nm.
Plug in the pressure monitor's connector.
Fill the system with refrigerant and check for leaks, see Filling with refrigerant See: Service and Repair/Filling With Refrigerant
