V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Disconnect the battery negative lead
B1: Replacing the cable harness between the SRS control module and the passenger airbag, service cable harness 1 (a section of a cable may not be
repaired)
Removing the cable harness from the dashboard bracket and
2
positioning the service cable
Remove the:
-
rear center console
-
center console locker and/or the radio
-
panel on the right-hand side of the center console.
Separate the connector to the passenger airbag side. Disconnect the connector and the clip from the dashboard bracket.
Position the new service cable harness along the existing cable harness under the center console against the dashboard bracket.
Installing the cable harness
3
MY 2000 - vehicles: Position the connector at the same height as the terminal.
MY 2001 - vehicles: Install the new service cable harness and clip in the mounting on the dashboard bracket.
Remove both of the cable terminals from the SRS control module connector, see method C: Removing and installing the service cable harness from the
connector to the supplemental restraint system control module (SRS).