V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Remove the boot by turning the circlip 1/4 turn and pulling the boot downwards.
Remove the gear selector knob by jerking it straight up by hand. A strong jerk is required.
Note: The knob cannot be reused.
Installing gear selector knob
-
Install the new gear selector lever knob by working and pressing it into position
-
Check that the knob has engaged by jerking it straight upwards
-
Check that the boot is positioned above the circlip
-
Secure the circlip to the gear selector knob by sliding the circlip straight upwards
-
Check the that the circlip is fully engaged.
Replacing Lock Function
Replacing lock function
Removal
Remove
-
the gear selector knob according to Replacing gear selector knob
-
the center console according to Transmission control module (TCM) diagnostic functions.
Pull out the pawl (1) with round-nosed pliers.
Remove the push rod and spring (4). If necessary, use a thin, bent welding rod to lift up the spring.
Installation