V50 L5-2.4L VIN 39 B5244S7 (2005)
Check the clearance between the clutch plate and pulley. Use a feeler gauge.
The clearance should ideally be 0.3 mm all the way around, although a play up to max. 0.5 mm is allowed.
Replace the shims if the clearance is not within the stated values.
Finishing
Installing components
Install:
-
the auxiliaries belts. See: Tensioner accessory drive belt See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and
Accessories/Drive Belt Tensioner/Service and Repair
-
the right-hand screw securing the air baffle
-
the right-hand fender liner using the 5 screws and the plastic nut
-
the right-hand front wheel.
-
the shield under the vehicle using the 7 clips. See the illustration.