V50 L5-2.4L VIN 39 B5244S7 (2005)
Remove:
-
the right-hand headlamp. See: Headlamp bulb See: Lighting and Horns/Headlamp/Headlamp Bulb/Service and Repair/Headlamp Bulb Headlamp
bulb See: Lighting and Horns/Headlamp/Headlamp Bulb/Service and Repair/Headlamp Bulb
-
the nut. Disconnect the pipe coupling (A) at the receiver.
Note! Plug the intake pipe for the receiver immediately after disconnection.
Installing the pipe/hose between the evaporator and the receiver
Note! For tightening torques, see Specifications. See: Body and Frame/Specifications
Install:
-
the pipe coupling at the receiver using the M8 nut
-
the right-hand headlamp. See: Headlamp bulb See: Lighting and Horns/Headlamp/Headlamp Bulb/Service and Repair/Headlamp Bulb Headlamp
bulb See: Lighting and Horns/Headlamp/Headlamp Bulb/Service and Repair/Headlamp Bulb.
Position the pipe / hose next to the cowl panel in the engine compartment.
Install:
-
the mounting block in the grooves on the pipe
-
the plastic clip holding the mounting block
-
the M8 screw securing the air conditioning (A/C) pipes to the evaporator.
Press in the hose into the mounting below the right-hand suspension turret.
Carry out finishing work. See: Finishing work (the same for all methods).
Pipe/hose between condenser and expansion valve, replacing
Removing components
