V50 L5-2.4L VIN 39 B5244S7 (2005)
New compressor
A new compressor intended for the engine type has the correct volume of oil from the factory.
Replacing the receiver
Replace the receiver in the following instances:
- When replacing the compressor (compressor seizure for example).
- Refrigerant leakage, where nearly 100% has leaked out of the system (system depressurized).
- When replacing any air conditioning (A/C) component outside the warranty period.
- When the system has been open / unplugged for more than 10 minutes.
Filling the A/C system with oil
Filling with PAG oil
Note! On newer filling/draining/vacuum pumping stations there is a reservoir for injecting oil. This can be used before filling with refrigerant
and after vacuum pumping without needing to remove the needle valve in the service valve.
Caution! Fill with oil before vacuum pumping.
Note! When replacing pipes or hoses the oil can be filled through the service valve.
Remove the needle valve in the service valve. Use: 951 1204 REMOVAL TOOL See: Tools and Equipment/951 1204 Removal Tool.
Use the filling syringe. Clean the syringe to avoid the possibility of mixing different types of oil.
Check according to the table above. Measure how much oil is to be added. After topping up the oil, reinstall the needle valve.
Note! Use only your thumb and index finger when tightening the service valve using valve needle tool 951 1204 REMOVAL TOOL See: Tools
and Equipment/951 1204 Removal Tool. This is to prevent damage to the seal on the valve.
