Volvo Workshop Manuals
V50 L5-2.4L VIN 39 B5244S7 (2005)
Relays and Modules > Relays and Modules - Brakes and Traction Control > Electronic Brake Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 744
951 2785 Crimping tool See: Tools and Equipment/951 2785 Crimping Tool
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
Caution! As the SRS system is a safety system, it is extremely important that these instructions are carefully followed when carrying out repairs
Caution! Ensure that the new pin has the same type of surface treatment as the old.
Warning! Do not carry out any work on the cable for the SRS system until the connector has been disconnected from the relevant airbag or
Selection of repair kit, SRS system
Materials: SRS system repair kit for the selected car.
Note! Only special tools and materials from the SRS system repair kit for the selected car must be used. Choose a repair location where there is
The cables should always be connected colour to colour. If the repair terminal colors do not correspond with the vehicle, check with the wiring diagram
Removing the battery lead and the ignition cable
Disconnect the negative battery cable. See: Battery, Disconnecting.
Cutting and stripping pairs of cables
|[PREV PAGE] [NEXT PAGE]|