V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Remove the foldable panels on the left and right-hand sides of the cargo compartment.
-
Remove the left-hand side panel. First remove the cover and the screw at the front edge of the panel
-
Pull the top of the panel out until the clips release
-
Fold the panel inwards. Lift the panel out
-
Repeat the operation on the right-hand side.
-
Remove the storage box from under the rear floor hatch by turning the clip on the left and right-hand sides 90°. Lift out the box.
-
Take the foam tape from the kit. Install the section of the long single cable to be routed under the sill trim panel for the tailgate. This is to prevent
rattling
-
Take the long single cable that was routed with the cable harness from the radio. Route the cable under the carpet to the left-hand side of the car
-
Clamp the cable at the existing cable harness at the left-hand side of the cross member. Use a tie strap (1) from the kit
-
Route the cable inside the carpet and under the cable ducts (2) and (3) along the left-hand side of the car towards the cargo compartment. Ensure
that the cable is securely pressed down between the sills and carpets
-
Route the cable under the existing wiring and the connectors by the cable duct (3).
-
Route the cable along the left rear wheel arch to the rear end of the left floor support
-
Remove the outer screws (1) in the tailgate sill trim panel
-
Pull up the tailgate sill trim panel on the left-hand side. Insert the cable between the floor support and the sill trim panel
-
Slide the cable in towards the rear crossmember as far as possible. Ensure that the cable is not trapped
-
Route the cable along the existing cable harness at the rear crossmember over to the right-hand side. Insert the cable between the sill trim panel
and the floor support in the same way as on the left-hand side.
-
Clamp the cable using tie straps (2)
-
Press the sill trim panel back into place. Reinstall the two screws.
