V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Take the Melbus cablem P/N 30664142, lift up the floor mat and route it underneath, up between the front air duct (1) and the strut (2) for the
centre console.
Note! Make sure that it is the connector with a guide pin which points upward (see illustration), which is routed to the radio socket.
-
Route the cable through the compartment for the radio.
-
Clamp the cable in the strut, using the clamp (3) from the kit.
-
Route the cable on above and alongside the front air duct to the member (4) for the seat mounting.
-
Clamp the cable at the existing cable harness (5).
-
Route the cable (1) under the carpet, along the left-hand side of the car to the rear door.
-
Route the cable further above and along the front cable duct (2). Continue along the right-hand side of the rear cable duct (3).
-
Route the Melbus cable (1) on the right side of the cable duct (2), below the cables of such, in the hole in the body at the bumper mounting and up
to the iPod adapter. Hide excess cable length under the floor mat on the passenger side.
For cars with pre-routed Melbus cable
-
Some cars are fitted with a long Melbus cable. Find the cable end, which is in the area (3) of the rear fuse holder.
