V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Applies to cars with a centrally mounted loudspeaker
-
Connect the three cables (1) to the display screen and the centrally mounted loudspeaker
-
Press the display screen and bracket into the dashboard. Tighten using the four existing screws (2)
-
Press the new loudspeaker grille (from the kit) into place on the dashboard.
Finishing work
-
Connect the green female connector on the new cable harness, to the green male connector disconnected from the radio
-
Connect the other two large connectors to the radio
-
Connect the other connectors removed from the radio
-
Reinstall the radio
-
Connect the connectors to the dashboard environment panel. Reinstall the panel
-
Reinstall the panel and gear selector lever boot around the gear selector lever
-
Reinstall the panel in front of the gear selector lever
-
Fold back the carpet
-
Reinstall the side panel on the centre console
-
Reinstall the sill trim panels on the left-hand side
-
Fold the left-hand front seat back into position
-
Tighten the front edge of the seat. Tighten the seat using the two new screws from the kit. Tighten the nut. Tighten to 40 Nm (30 lbf. ft). Reinstall
the covers over the screws
-
Reinstall the parcel shelf
-
Reinstall the C-post panels. Press the rubber mouldings into position
-
Reinstall the front side panel in the cargo compartment
-
Connect the cargo compartment lighting connectors to the tailgate sill trim panel. Reinstall the sill trim panel
-
Install a new left-hand folding panel from the kit. Reinstall the right-hand panel
-
Reinstall the side cushion
-
Fold the backrest back into place
-
Fold the seat cushion back into place.
-
Turn the ignition key to position II
-
Reconnect the battery negative lead
-
Reinstall the cargo compartment carpet
-
Program the software according to the service information in VIDA.
