volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Bag Holder|Page 27593 > < Bag Holder|Page 27591
Page 12
background image

-

The new floor hatch has two decals with instructions on how to use the jack for two wheel or four wheel drive cars.

Applies to two wheel drive cars:

-

Remove the decal with P/N 9454320 (see the lower right corner of the decal) from the floor hatch.

Applies to four wheel drive cars:

-

Remove the decal with P/N 9454319 (see the lower right corner of the decal) from the floor hatch.

-

Lift the rear edge of the rear floor hatch 10-15 cm (4-5") to remove it. Then detach the floor hatch by pulling it backwards out of its mountings.
The hatch is securely installed. Detach one side at a time

-

Place the floor hatch to one side. The floor hatch will not be reused.

-

Check the floor supports to see if there is a lug protruding from them which is used to hook the support belt for the carrier bag holder

-

If there is a lug. Proceed directly to point 13.

Bag Holder|Page 27593 > < Bag Holder|Page 27591