V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Remove the screw on the left-hand side of the tailgate sill
-
Remove the three screws from the left-hand floor support
-
Repeat the operation on the other side
-
If the car has a CD or RTI system, disconnect their screws and note how the washers are installed
-
Lift up the front edge of the floor supports. Pull the floor supports forward.
-
Place the floor supports upside down
-
Take out the brackets with lugs from the kit. Align the brackets with the lug in the hole and the hole in the bracket on the locating pin for the floor
support
-
Press the brackets into place so that the hooks hold them in position.
-
Reinstall the left and right-hand floor supports on both sides
-
Carefully press the insulation back into place
-
Tighten the floor supports in the floor. Tighten using the three screws and using the screw through the tailgate sill trim panel
-
Reinstall the CD/RTI units if applicable. Tighten the CD/RTI units using the previously disconnected screws and washers
-
Reinstall the insulation panel cargo compartment. Install the storage box
-
Reinstall the side panels. Reconnect the 12V socket connector if this was disconnected
-
Reinstall the front floor hatch
-
Fold the rear backrests up on both sides.
