V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Tighten to 17 Nm
Install the integrated relay / fusebox and the connector for the ABS unit
Install the air cleaner (ACL) housing
See Brake pie master cylinder / ABS unit, replacing
Install the cross member
See Brake fluid reservoir, replacing
Fill and bleed the brake system
See Brake system bleeding Fusing bleeding unit)
Checking the power brake booster
Depress the brake pedal several times to so that it has no travel.
Hold the pedal down. Start the engine. The pedal should travel and feel softer.
Release the brake. switch off the engine. Wait 1 minute. Then depress the pedal. The pedal should still feel soft but should become stiffer when it is
depressed several times.
There should be no leakage between the vacuum hose and the terminal at the power brake booster.
There should not be any leakage between the master cylinder and the power brake booster.
Check that the stop lamp functions.
If the stop lamp switch has been modified or changed after installation of the master cylinder and power brake booster it must be readjusted.
Bushing, Push Rod, Replacing
Bushing, push rod, replacing
Remove bushing
Remove:
-
the driver's side soundproofing panel.