V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Release the heated oxygen sensor (HO2S) wiring from the rear engine mounting.
Remove the nuts where the manifold and the front exhaust pipe divide.
Disconnect the brake pipe from the holder on the SIPS member.
Remove the screws holding the SIPS member to the bodywork.
Press the exhaust system backward.
Removing components
Remove
-
the cross stay between the suspension turrets
-
the hose and connector from the air assisted control valve
-
the intake hose between the mass air flow (MAF) sensor and the electronic throttle module (ETM)
-
the crankcase ventilation hose from the connection at the inlet hose
-
the cover over the ignition coils
-
the upper timing cover.
Remove
-
the ground strip from the cylinder head
-
the air preheater hose between the air cleaner and the heat deflector plate above the manifold
-
the torque rod bracket
-
the pipe screw for the water heated crankcase ventilation at the rear of the cylinder head
-
the camshaft position sensor (CMP) housing and trigger wheel
