V70 2.4 L5-2.4L VIN 61 B5244S (2001)
To clean the shaft journal and mating surface, use emery cloth P/N 951 1024.
Note! Cleaning shall be done in the direction around the shaft journal, not in and out. It is very important that any residue from the emery
cloth or any other contaminants are completely removed before the new seal ring is installed.
Use drift 999 5450 PUNCH See: Tools and Equipment/999 5450 Punch.
Lubricate the surface of the seal that the camshaft rotates against.
Press in the seal until the drift bottoms out.
Note! If there are wear grooves on the camshaft the seal can be pressed in another 2 mm, by turning around the tool's sleeve.
Install camshaft adjustment tool 999 5452 CAMSHAFT ADJUSTMENT TOOL See: Tools and Equipment/999 5452 Camshaft Adjustment Tool at the
rear of the camshafts.
Check that the screws securing the adjustment tool to the camshafts and the screws holding the tool together are well tightened.
Installing the front camshaft seal
Lift up the brake fluid reservoir and the expansion tank. Place them on top of engine.
Use drift 999 5718 Drift See: Tools and Equipment/999 5718 Drift for camshaft with variable valve timing unit and drift 999 5719 Drift See: Tools
and Equipment/999 5719 Drift for camshaft without variable valve timing unit.
Lubricate the surface of the seal that the camshaft rotates against.
Use the variable valve timing unit / timing belt pulley mounting screws. Tighten the screws until the drift bottoms out.
Remove the drift
Install the screw holding the inner timing cover to the cylinder head.
Checking and adjusting the variable valve timing unit
Check and adjust the variable valve timing unit. See: Variable valve timing unit, checking and adjusting See: Actuators and Solenoids - Engine/Variable
Valve Timing Actuator/Testing and Inspection.
Installing components