V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Removal
1
Remove the:
-
splash pan
-
four screws for the front cross member
-
screws for the exhaust pipe mounting in the front cross member
-
brake pipe from its holder in the member
-
clamp for the wiring for the heated oxygen sensor from the subframe.
Installing, marking and drilling
2
Raise the exhaust system. Use a jack stand. Hold the bracket on the subframe.
Centre the console in relation to the mounting on the catalytic converter/exhaust pipe.
Mark the positions of the holes (A) on the subframe.
Vehicles where the heated oxygen sensor wiring is attached at the right side with a clip a new hole (B) has to be made.
Mark for a new hole (B) for the heated oxygen sensor wiring so that it is approximately 10 mm to the right of the bracket.
Remove the:
-
the bracket
-
the mounting from the three-way catalytic converter (TWC)/exhaust pipe (S80 only).
Drill:
-
two pilot holes (A) using a 3 mm (1/8") drill bit
-
enlarge using a 11 mm (7/16") drill bit
-
hole (B) for the heated oxygen sensor wiring using a 5 mm (13/64") drill.