V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Seat/Upholstery, Seat Cushion, Replacing
-
the insulation
-
the four nuts
-
the inspection hatch for the fuel tank unit.
Disconnect the quick-release connector (as illustrated). Pull up the fuel hose.
Installing the fuel line for the engine coolant heater
Install the fuel line.
Connect the fuel line to the fuel pump (FP).
Check that the tilt angle on the fuel pump (FP) is 15°.
Connect the fuel line from the fuel pump (FP) and forward to the sub-frame and fuel line.
Install the fuel line on the clip and the fuel terminals.
Final check
Note! Start the engine and let it idle for a few seconds before starting the heater.
Test run the heater. Check the function of the heater. See Engine coolant heater, test running See: Testing and Inspection/Component Tests and General
Diagnostics/Engine Coolant Heater, Test Running.
Check for leakage in the engine coolant hoses or fuel lines.
Top up the coolant if necessary.
Check that no diagnostic trouble codes (DTC) have been stored during the repair work.
Screw the inspection hatch for the fuel tank unit into place.
Install:
-
the insulation and the cushion
-
the splash guard under the engine
-
the air baffle
-
the wind deflectors.
