V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Route the electrical cable from the electronic throttle module (ETM) behind the starter motor bracket.
Fit the bolt in the engine block. Tighten the two nuts and the bolt. Plug in the connector and install the cable tie.
Note!
If the cable was not routed behind the starter motor bracket, fasten the cable along the cable duct using two strip clamps.
Raise the car. Remove the cover from below the engine. Tighten the 4 electronic throttle module (ETM) bolts. Tightening torque 10 Nm. Install the
cover below the engine. Lower the car.
Install:
-
the fan cowling with its 4 bolts
-
the connector retainer before the lower bolt on the fan cowling's (car's) left side is inserted. Tighten the lower bolts. Insert the 2 upper bolts.
-
the fan connectors
-
the electric cooling fan relay in the holder
-
the EVAP valve to the fan cowling
-
the connector with retainer on the right side of the fan cowling
-
cable ties around electrical cables
-
hoses and electrical cables in their retainers/clips
-
the charge air hose to the intercooler
-
the relay holder and tighten the upper bolts.
Installing the charge air pipe
