V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Install:
-
the screws for the control system
Note! The different screw lengths are given in mm. See the illustration.
-
a new gasket for the cover on the control system.
Tighten the screws alternately to light contact. Then tighten to applicable specifications.
Install:
-
the new cable harness. Connect the connectors to the solenoids
-
the oil temperature sensor with the holder and screw. Tighten. See the relevant specifications.
Note! Screw length given in mm as illustrated.
Install the cable harness on the holder. Check that the cable harness is correctly positioned.
Installing the control system cover
Check that the mating surface for the cover is level.
Wipe the cleaned mating surfaces on the cover and transmission.
Note! Ensure that no dirt gets into the transmission.
Apply an approximately 3 mm thick bead of sealing compound to the cover.
Also apply sealing compound around the screw holes.
