V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Position the mobile jack under the right side of the sub-frame. Press the frame up. Install 2 x M14 new screws in the same way as on the left-hand side.
Remove the jack.
Finally tighten the four frame screws. See applicable specifications.
Tighten the support plates. See applicable specifications.
Install:
-
new locking nuts and screws for the steering gear. Tighten. See the relevant specifications.
-
the screw for the front engine pad. Tighten. See the relevant specifications.
-
new screws for the torque rod mounting. Tighten. See applicable specifications
Press the power steering line into the holders on the sub-frame.
Install the anti-roll bar link on the anti-roll bar.
Use a new nut.
Tighten. See applicable specifications
Caution! Use a torx wrench (1) as a counterhold. Do not damage the boot.
