V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Flywheel: Specifications
Install:
-
The 3 studs belonging to tool 999 5678, distributed as illustrated
-
the flywheel.
NOTE:
-
Check that the locating pin on the crankshaft is positioned opposite the hole in the flywheel.
-
Only applies to cars with dual mass flywheels: There is a marking in the form of a shallow hole (see the arrow). The marking indicates the
direction to the guide hole on the flywheel.
Locate gear sector 999 5112 against the flywheel.
Alternately tighten the nuts on the flywheel to the crankshaft. Use the three nuts which belong to tool 999 5678.
CAUTION: The flywheel must lie against the crankshaft flange before the screws are installed. There is a risk that excess locking fluid on the screws
will come between the mating surfaces.
Install 7 new screws. Tighten crosswise. Tighten to 45 Nm.
Remove the 3 nuts and studs.
Install the remaining 3 new screws for the flywheel. Tighten to 45 Nm. Then angle-tighten all 10 screws crosswise. Tighten to 65 degrees.
