V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Check if there is still air in the system. Press down the brake pedal using a jack at a pressure equivalent to heavy braking, 200 Nm. With the engine off
and the brake pedal depressed 3-4 times, the pedal travel must not exceed 40 mm.
If the pedal travel exceeds this limit, bleed again and re-check the pedal travel.
That there is no brake fluid leakage.
Remove the bleed unit connector from the brake fluid reservoir.
Check that the brake fluid level is not above the maximum marking.
Brake Pipe, Hydraulic Unit / Front Wheel / Junction, Replacing
Brake Pipe From Hydraulic Unit / Front Wheel / Junction, Replacing
Preparation
Disconnect the battery lead
Preparations when replacing brake pipes (applies to all brake pipes)
Switch off the ignition. Collect the brake fluid
Removing the integrated relay / fusebox
-
Remove the nut for the positive cables
-
lift the cable terminals away from the screw
