V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Transferring components when replacing the intake manifold
-
Transfer the electronic throttle module.
-
Use a new gasket.
-
Tighten to 10 Nm.
Installing the intake manifold and gasket
NOTE: Ensure that the gasket faces are clean.
Install
-
a new gasket held in position by the lower screws for the intake manifold. Do not forget the clamp for the fuel line at the screw in the lower row.
-
the intake manifold. Do not forget the crankcase ventilation hose. The hose must be inserted up through the gap between the second and third ducts
-
the three upper screws. Tighten all the screws (starting from the center). Tighten to 20 Nm.
Finishing
Install
-
the fuel rail.
Press together the quick-release connector. Use new screws. Tighten to 10 Nm