V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Removing components
Remove
-
the clamp between the oil pressure pipe and the oil return line at the turbocharger (TC)
-
the pipe screw that holds the oil pressure pipe to its connector on the cylinder block
-
the oil return line. Seal the opening in the cylinder block
-
the screws and spacers at the exhaust manifold support bracket
-
the lower screw that holds the heat deflector plate over the turbocharger (TC)
-
the nuts for the front exhaust pipe connection to the turbocharger (TC).
Lift off the exhaust pipe and tie it up. Seal the opening in the exhaust pipe.
Note! The front exhaust pipe's metal hose is very sensitive to twisting. Handle it with care to avoid leakage later on.
Draining the fuel line
Lower the car.
Drain the fuel line. See Fuel system pressure release See: Cylinder Head Assembly/Fuel Pressure Release/Service and Repair.
Removing components
Remove
-
the engine stabilizer brace between the suspension turrets.
-
the ground strips between the engine and the bulkhead
-
the heat deflector plate above the turbocharger (TC).
-
the plastic charge air pipe above the engine. Seal the openings
-
the cover over the ignition coils
-
the upper engine coolant hose for the engine and radiator
-
the screw holding the dip stick pipe to the intake manifold.
-
the brake vacuum hose from the intake manifold.
Undo the clamp holding the plastic charge air pipe to the electronic throttle module.