V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Remove
-
the EVAP hose from the intake manifold
-
the by-pass valve vacuum hose
-
the upper row of screws holding the intake manifold to the cylinder head. Slacken off the lower screws
-
the pipe screw for the crankcase ventilation from the underside of the intake manifold.
Disconnect the connector for the electronic throttle module.
Lift up and remove the intake manifold.
Note! Make sure that the fuel delivery pipe is not damaged.
Removing components
Disconnect the connectors for the ABS sensor and level sensor in the expansion tank.
Lift up the expansion tank and servo oil reservoir. Place them on top of the engine.
Note! Make sure that power steering fluid does not leak from the breather hole in the filler cap.
Take off the auxiliaries belt.
Remove
-
the front timing cover
-
the hose for the water-heated crankcase ventilation from the thermostat housing.
Separate the connector for the engine coolant temperature (ECT) sensor.
Setting up the engine
